Description:

SPC 3300mAh/25C/3S/11.1V, Lithium Polymer (LiPo) Battery Pack in a square-type, plastic tube over the length of the pack and the pack ends are covered with a dense foam rubber seal. Lower cost solution to 3S LiPo, high speed for your brushless RC vehicle. YES, this pack easily powers a brushless system like the Traxxas VXL! 25C continuous discharge with high quality, 12 Gauge leads (100mm long) & JST XH4 balancing connector. End exit wires with Tamiya connector. Up to 2C (6.6-Amp) charge rate! PACK DIMENSIONS: 25mm x 45mm x 132mm, 285g. (Please check your vehicle for size and fit) This pack will fit in nearly any 1/10th scale, ground-based vehicles, however chassis modifications may be required for others. If you have any questions or concerns about the following, please contact us before ordering: DO NOT leave charging battery pack unattended. Use only chargers for LiPo batteries that utilize a CC/CV method cut-off function. We recommend any charge rate up to 2C or 6.6-Amps. Charge in LiPo Sack or similar safety device at all times. Balancing is absolutely necessary and required each and every time you charge the battery pack! If using a stand-alone type balancer, balance the pack BEFORE charging. Use a Low Voltage Cutoff device (LVC) in your RC vehicle and NEVER run the pack down until the RC car is just barely moving. Stop driving when you notice the vehicle slowing and/or the motor begins losing power. If the battery pack is damaged and the case shows signs of swelling, discontinue use immediately and dispose of battery pack properly. SPC is not responsible for battery pack damage and/or failure resulting from improper balancing and charging, improper discharging, soldering heat or not following instructions. SPC is not responsible for any personal injury and/or damage involving this product. SPC will not warranty packs physically damaged as a result of abuse and/or impact of any kind.